MIMAKI UJV500-160 - Chapter 3 Extended Functions; List of Functions

3-2
List of Functions
This section describes the overview of each function to be set and set values that can be registered in user types.
• About default “HOST” function
You can operate this by the setting value specified in RIP software.
When you set to other than “HOST”, it operates by that setting value, not by the instruction from RIP software.
Depending on RIP software, there are some functions that cannot be instructed by software. In such a
case, it operates by the setting value of “When no instruction from RIP exists”.
• For the specifying method with the RIP software, refer to the operation manual of the RIP software.
Function name Set value Default
When no instruction
from RIP exists
*1
Outline
FEED COMP. ( P.2-34) -9999 ~ 0 ~ 9999 0
Used to print a pattern for
correcting a media-feeding
rate and correct it.
DROP. POS CORRECT
(P.2-36)
-40.0 ~ 0 ~ 40.0 0
Used to adjust the dot
position in go and return
printing.
HEATER
(P.2-28)
MEDIA
HEATER
PRE
OFF/ 20 to 60°C
(OFF/ 68 to 140°F)
OFF
Sets heater conditions.PRINT
OFF/ 20 to 60°C
(OFF/ 68 to 140°F)
OFF
POST
OFF/ 20 to 70°C
(OFF/ 68 to 158°F)
OFF
INK HEATER
Standby
Switcho
verTIM
NONE, 0 to 60min 2min
Sets the movement time until
the head heater and ink
heater standby status.
LOGICAL SEEK
(P.3-5) HOST / ON / OFF HOST
ON
Sets the scan movable area
during printing.
INK LAYERS ( P.3-20) HOST /1 to 9 HOST
1
Sets the number of layers in
which ink is to be applied.
MARGIN
(P.3-6)
LEFT
HOST / -10 to 85mm
(1mm unit)
HOST
0 mm
Sets a non-printing area
along the right and left edges
of the media.
RIGHT
HOST / -10 to 85mm
(1mm unit)
HOST
0 mm
UV MODE
(P.3-7)
HOST / MANUAL HOST
PATTE
RN
HOST -50 to +50%
0 ％
Operates with the
manual settings of
LED UV lamp,
Pattern A, Lv10,
Post cure UV
lamp and ON
Sets and adjusts the intensity
of the UV lamp.
MANU
AL
LED UV
LAMP
PATTERN A to F,
Lv1 to 10
PATTERN A
Lv5
POST
CURE
UV LAMP
ON/OFF
ON
CONT
ROL
FULL
Sets the light control method
for the UV lamp.
PRINT
LAMP
POS
0 to 180mm 0mm
REFRESH (
P.3-20)
HOST / Lv.0 (Refresh
interval long) ~ 3 (Refresh
interval short)
HOST
Lv.3
Refreshes the print heads
during printing.
VACUUM ( P.3-20)
HOST / STANDARD /
STRONG
HOST
STANDARD
Sets the absorbability of the
media.
FEED SPEED ( P.3-20) HOST / 10 ~ 200%
*2
HOST
100%
Changes the media feeding
speed in printing.