MIMAKI UJV500-160 - Set the Network

3-34
Set the network
You can also perform network setting with “Network Configurator”, the tool to perform network setting of
Mimaki’s product. To download the Network Configurator, check " Driver / Utility" on the download page at
Mimaki Engineering (http://eng.mimaki.co.jp/download/).
1
Press the key in LOCAL.
2
Press to select [MACHINE SETUP].
3
Press the key.
4
Press to select [NETWORK & MAIL].
5
Press the key twice.
6
Press the key.
• The IP address currently used by this machine is displayed.
7
Press the key.
8
Press to select [MAC Addr.].
9
Press the key.
• The MAC address currently used by this machine is displayed.
10
Press the key.
11
Press to select [DHCP].
• After connecting with the network, it takes time until the IP address is determined.
If the IP address has not been determined, “0.0.0.0” is displayed.
FUNCT I ON
SETUP [ ENT ]
FUNCT I ON
MACH I NE S E TUP [ ENT ]
MACH I NE S E TUP
AUTO Powe r - o f f [ ENT ]
MACH I NE S E TUP
NETWORK & MA I L [ ENT ]
NETWORK
Chec k I P Add r . [ ENT ]
Chec k I P Add r es s
10 . 16 . 168 . 235
NETWORK
Chec k I P Add r . [ ENT ]
NETWORK
Ch e c k MAC Add r . [ ENT ]
Check MAC Address
00 : 0d : 1b : 00 : 00: 00
NETWORK
Ch e c k MAC Add r . [ ENT ]
NETWORK
DHCP [ ENT ]