3-36
Setting event mail function
Set the function to send e-mails to the set e-mail address when events such as cutting start/ end and stop due
to an error.
You can also perform network setting with “Network Configurator”, the tool to perform network setting of
Mimaki’s product. To download the Network Configurator, check " Driver / Utility" on the download page at
Mimaki Engineering (http://eng.mimaki.co.jp/download/).
Enable the event mail function
1
Press the key in LOCAL.
2
Press to select [MACHINE SETUP].
3
Press the key.
4
Press to select [NETWORK & MAIL].
5
Press the key.
6
Press to select [EVENT MAIL].
7
Press the key.
8
Press the key.
9
Press to select “ON”.
Disclaimer
• The customer is responsible for the communication fee for Internet communication such as e-mail notification.
• The notification by the event mail function may not be delivered due to Internet environment, failure of the
device/ the power supply, etc. Mimaki has absolutely no responsibility for any damages or loss resulting from
non-delivery or delays.
• You can use event mail function by connecting LAN to this machine. Please prepare for LAN cable
connection beforehand.
• Not compatible with SSL communication.
To Next Page
Loading...
