4-8
12
Clean the flushing tray.
• Wipe off the ink of the cap rubber and cap cover with clean stick or waste cloth dipped in cleaning
solution for maintenance.
13
Press the key after the cleaning.
14
Close the lower right maintenance cover then press the key.
• After its initial operation, the machine returns to step1.
Performing the station maintenance without key
You can select station maintenance by using the key in the Local without pressing the key.
• The coating may peel, but this does not cause any functional problems. It may get stuck to
the carriage, though, so peel and wipe away any coating that is peeling.
Press the
key in Local.
Press to
select [MAINTENANCE].
Press the key twice.
• It becomes the same condition as the
key is pressed from Local.
To Next Page
Loading...
