MIMAKI UJV500-160 - Page 118

3-42
14
Press to set [SMTP Port] .
• Set the SMTP port number.
15
Press the key.
16
Press the jog key to select
[Authentication] .
17
Press the key.
18
Press to set authentication method .
• Set the authentication method of the SMTP server.
• When you select [OFF], proceed to the Step 32.
19
Press the key.
20
Press to select [SENDER ADDRESS].
21
Press the key.
• Press and set the e-mail address to be
used as the sender mail address.
• Set it with alphanumeric characters and symbols within 64 characters.
22
Press the key.
23
Press to select [User Name].
24
Press the key.
• Press to set the user name to use for the
authentication.
• Set it with alphanumeric characters and symbols within 30
characters.
25
Press the key.
• Depending on your server, if you do not set the e-mail address not supporting the account,
sending/ receiving e-mails may be unavailable.
SERVER SETUP
SMTP Po r t No . [ ENT ]
SERVER SETUP
Au t hen t i ca t i on [ ENT ]
Au t hen t i ca t i on
:POP before SMTP
Au t hen t i ca t i on
:POP before SMTP
SERVER SETUP
Au t hen t i ca t i on [ ENT ]
SERVER SETUP
SENDER ADDRESS [ ENT ]
SENDER ADDRESS
SERVER SETUP
SENDER ADDRESS [ ENT ]
SERVER SETUP
Use r Name [ ENT ]
Use r Name
SERVER SETUP
Use r Name [ ENT ]