MIMAKI UJV500-160 - Page 144

4-14
6
Wipe ink sticking to the side of the head off with a clean stick.
• Never rub the nozzles.
7
Clean the bottom surface of the UV lamp.
• If there is any ink stuck on the rear side of the bottom surface of the UV lamp, apply the cleaning
solution for maintenance to a clean stick and wipe the ink away.
Wipe off so that cleaning solution for maintenance will not remain.
• Clean the wiper until it looks as shown in the photo on the
right.
The nozzle part (Never
touch it.)
Clean the side surface of the head (shown in deep gray) with a clean
Be careful not to touch
the cutter blade.
Clean with a clean stick or
a waste cloth.