START
Startup the system, and trial the
add-on library.
Refer to the add-on library instruction manual.
The license period decreases with operating time
(time the Motion power supply is ON).
Add-on
library trial
Install add-on library.
Connect the personal computer and
Motion CPU.
Insert USB dongle in personal computer.
If a license is purchased, a USB license key (USB dongle with
license information) is supplied.
*: To cancel trial, uninstall the add-on library.
License
purchase
To continue trialing the add-on library,
purchase a license.
Turn ON the power supply of Multiple
CPU system.
Put the Motion CPU in installation mode.
Set the Motion CPU rotary switch to "A".
Refer to the following for details on rotary switch.
¢
MELSEC iQ-R Motion Controller User’s Manual
License key
generation/
writing
Perform the following in MT
Developer2.
*1
• Select add-on library.
• Generate license key.
• Write the license key to the Motion
CPU.
Read the serial No. (production information) of the connected
Motion CPU, and generate the license key.
Turn OFF the power supply of Multiple
CPU system.
Put the Motion CPU in normal mode.
Set the Motion CPU rotary switch to "0".
Refer to the following for details on rotary switch.
¢
MELSEC iQ-R Motion Controller User’s Manual
Turn ON the power supply of Multiple
CPU system.
Confirmation
of license
authentication
Check that the license authentication
information screen in MT Developer2
is "Authentication complete".
*1
END
Check the license period in the license
authentication information screen of
MT Developer2.
*1
In the transfer setup, set the connection
(communication) method for the
personal computer and Multiple CPU
system.
To Next Page
Loading...
