Mitsubishi Q02CPU

10
- 18
10.1 Scan Time
10.1.4 Factors that can shorten scan time by changing the settings
10
CPU MODULE PROCESSING TIME
(2) Floating point arithmetic processing ( Section 8.1.2(2))
Note10.12
Note13
The time required for the arthmetic processing of the instruction using a floating point
can be shortened by selecting "Do not perform internal operation processing with
double precision" (remove the check mark on the setting screen) in the PLC system
setting.
Remark
Refer to the following manual for the arithmetic processing time of the instruction
using a floating point.
QCPU (Q Mode)/QnACPU Programming Manual (Common Instructions)
Note13
Diagram 10.6 Floating point arithmetic processing screen
Basic
Process Redundant
Note10.12
Note10.1
2
Note10.12
The Basic model QCPU, Process CPU and Redundant CPU do not support the floating-point
arithmetic processing setting.
Basic
Process Redundant
Note10.12Note10.1
2N
ote10.12
Remove checkmark!