Mitsubishi Q02CPU User Manual

9
PARAMETERS
9.3 Network Parameters
9 - 37
9
Parameters
10
Device Explanation
11
CPU Module Processing Time
12
Procedure for Writing Program to CPU ModuleAppendicesIndex
(2) MELSECNET/H setting
The network parameter of the MELSECNET/H is set.
* 1 : Can be set only when the Redundant CPU is used.
* 2 : Can be set only when the Process CPU or Redundant CPU is used.
Figure 9.28 Number of modules on Ethernet/CC IE/MELSECNET. (for MELSECNET/H setting)
Table9.32 MELSECNET/H setting list
Item Parameter No. Description Setting range Default value Reference
Number of modules on
MELSECNET/H
5000
H
Set the MELSECNET/H network
parameters.
Refer to the manual for the Q
corresponding MELSECNET/H
---- ----
Starting I/O No.
5NM0
HNetwork No.
Total stations
Group No. 05mnH
Mode 5NM0H
Refresh parameters 5NM1H
Setup Common
parameters
5NM2
H
Station inherent
parameters
5NM3
H
Sub-master parameters*
2
5NM5H
Setup Common
parameters 2
5NMA
H
Station inherent
parameters 2
5NMB
H
Interrupt settings
Group setting
*1
D004H
Redundant settings
*1
D5**H
Valid module during other
station access
5001
H
Interlink transmission
parameters
5002
H
Routing parameters 5003H

Mitsubishi Q02CPU Specifications

General

Brand	Mitsubishi
Model	Q02CPU
Category	Controller
Language	English