Mitutoyo HM-200A Series - Outputting the Result Data of the Previous Hardness Test

No. 99MBG127A
5-46
Fig. 5.2 Diopter adjustment of the ocular
<Folding the eyepiece rubber hood>
If the rubber hood is in your way, fold it outward.
Fig. 5.3 Folding the rubber hood
5.7.4 Outputting the result data of the previous hardness test
With the operation in the "MEASUREMENT" screen, the result data of the previous hardness test
can be output to the external output connector.
It is possible to output only the required data.
The data can be output even when the external output connector is disabled by the setting.
Refer to "8.7.4 Specifications of external output" for the output format.
CAUTION
1. The result data of the hardness test is output to a peripheral device even when the
external output connector is disabled by the setting.
2. If the test condition is changed after the harness test, a wrong test result may be
output.
3. Make sure to turn on the power to each peripheral device after turning on the power
to the hardness testing machine.
1. Press the button.
2. The result data of the previous hardness test will be output to a peripheral device.
Rotate this part.