Mitutoyo HM-200A Series - Connecting with Printer DPU-414; Connecting DPU-414; Software DIP SW Settings

8. SPECIFICATIONS
No. 99MBG127A
8-9
8.6 Connecting with printer DPU-414
8.6.1 Connecting DPU-414
8.6.2 Software DIP SW settings
Set up the initial state, input method, etc. of DPU-414.
Follow the steps below.
Pro-
cedure
Operation Print contents Operation
1
Turn off the Power
switch of DPU-414.
Pwer OFF
2
Set the power switch to
"ON" while pressing the
[On line] key.
The function settings at
present are printed. The
following is printed in closing:
Continue?: Push ‘ON-line SW’
Write?: Push ‘feed SW’
Printing of settings at
present
3
Press the [On line] key
to start the setting of
"Dip SW-1".
DP SW-1
Start of function
setting Dip SW 1
4
Press the switches in
the following order.
[Feed]→[On line]→
[On line]→[Feed]→
[On line]→[Feed]→
[On line]→[On line]
(OFF) (ON) (ON) (OFF)
(ON) (OFF) (ON) (ON)
Continue?: Push ‘ON-line SW’
Write?: Push ‘feed SW’
Input method:
Serial input
Printing speed:
High Speed
CR function: Recover
Print density: 100%
5
Press the [On line] key
to start the setting of
"Dip SW-2".
DP SW-2
Start of function
setting Dip SW 2
DPU-414 (Printer)
SERIAL
HM-200A
EXT. LOAD
SERIAL
Connecting cable
(No.02AGD620A)