8. SPECIFICATIONS
No. 99MBG127A
8-5
8.3 Consumables and Service Parts
Code No. Item name Specifications
Special
instructions
19BAA058
Diamond
indenter
Vickers with liner: for HM-210 Note 1
19BAA059
Diamond
indenter
Vickers (for low test force) with liner:
for HM-220
Note 1
19BAA061
Diamond
indenter
Knoop with liner: for HM-210 Note 1
19BAA062
Diamond
indenter
Knoop (for low test force) with liner: for HM-220
Note 1
Note Equivalent to the indenter included in this product
8.4 Optional Accessories
Code No. Item name Remarks
Special
instructions
19BAA001 Hardness standard block 100HMV (test force: 9.807N, 980.7mN, 98.07mN)
19BAA002 Hardness standard block 200HMV (test force: 9.807N, 980.7mN, 98.07mN)
19BAA003 Hardness standard block 300HMV (test force: 9.807N, 980.7mN, 98.07mN)
19BAA004 Hardness standard block 400HMV (test force: 9.807N, 980.7mN, 98.07mN)
19BAA005 Hardness standard block 500HMV (test force: 9.807N, 980.7mN, 98.07mN)
19BAA006 Hardness standard block 600HMV (test force: 9.807N, 980.7mN, 98.07mN)
19BAA007 Hardness standard block 700HMV (test force: 9.807N, 980.7mN, 98.07mN)
19BAA008 Hardness standard block 800HMV (test force: 9.807N, 980.7mN, 98.07mN)
19BAA009 Hardness standard block 900HMV (test force: 9.807N, 980.7mN, 98.07mN)
19BAA010 Hardness standard block 40HMV (test force: 9.807N, 980.7mN, 98.07mN)
810-016 Standard vise Opening width: 51 mm
810-017 Special vise Opening width: 100 mm
810-013 Thin table Thickness: 5 mm or less
810-014-1
Table for thin block
(horizontal type)
Dia. 0.4 to 3.6 mm
810-015-1
Table for thin block
(vertical type)
Dia. 0.4 to 3.6 mm
810-019 Specimen tilting stage
Opening width: 37 mm, tilting angle: ±15 degrees,
rotating angle: ±25 degrees
810-020 Flexible specimen stage Thickness: within 30 mm
810-018 Turntable Minimum reading: 1°
810-084
Rotatable flexible
specimen stage
Height: 32 mm or less,
width and diameter: 38 mm or less
810-085 Thin plate specimen table Thickness: 3 mm or less, width: 56 mm or less
To Next Page
Loading...
