Mitutoyo HM-200A Series - Connecting Printer DP-1 VR

No. 99MBG127A
8-6
8.5 Connecting Printer DP-1 VR
NOTE
· When Mitutoyo DP-1VR is used, set the interface mode to COMPATIBLE.
· The default interface mode is set to ADVANCED. If the printer is used in the
ADVANCED mode, printing may not be performed. Be sure to select the interface
mode.
1. Connect the AC adapter to DP-1VR or put 4 AA nickel hydride or alkaline batteries in
DP-1VR.
2. Load printer paper.
Code No. Item name Remarks
Special
instructions
810-095
Rotatable tilting
specimen stage
Height: 20 mm or more, width and diameter: 15 to 55
mm
810-650-1
Resin molded
specimen stage, Ø 25.4
Ø25.4±0.5mm, Specimen height: 9 to 39mm
810-650-2
Resin molded
specimen stage, Ø 30
Ø30.0±0.5mm, Specimen height: 9 to 39mm
810-650-3
Resin molded
specimen stage, Ø 31.75
Ø31.75±0.5mm, Specimen height: 9 to 39mm
810-650-4
Resin molded
specimen stage, Ø 38.1
Ø38.1±0.5mm, Specimen height: 9 to 39mm
810-650-5
Resin molded
specimen stage, Ø 40
Ø40.0±0.5mm, Specimen height: 9 to 39mm
375-056 Objective micrometer Scale: 1 mm, min. scale value: 0.01 mm
19BAA242 Connecting cable RS-232C-compliant, (9P-9P), 2 m
02DGD600A Printer Model: DPU-414 (Seiko Instruments Inc.)
19BAA157 Rolled paper For DPU-414 10 roles/set
264-504 Digimatic mini-processor Model: DP-1VR (Mitutoyo)
937387 Connecting cord For DP-1 VR
09EAA082 Printer paper For DP-1 VR 10 roles/set
02ATE760 Table 1800(W)x900(D)x740(H), testing machine and PC
Common with
QS
810-641
Installation base (vibration
removal board equipped)
Only testing machine is mountable.
11AAC146 Fall prevention plate