No. 99MBG127A
8-10
Pro-
cedure
Operation Print contents Operation
6
Press the switches in the
following order.
[On line]→[On line]→
[On line]→[On line]→
[On line]→[On line]→
[On line]→[On line]
(ON) (ON) (ON) (ON)
(ON) (ON) (ON) (ON)
Continue?: Push ‘ON-line SW’
Write?: Push ‘feed SW’
Print mode: 40 digits
International
characters: Japanese
7
Press the [On line] key to
start the setting of "Dip
SW-3".
DP SW-3
Start of function
setting Dip SW 3
8
Press the switches in the
following order.
[On line]→[On line]→
[On line]→[On line]→
[Feed] →[Online]→
[On line] →[On line]
(ON) (ON) (ON) (ON)
(OFF) (ON) (ON) (ON)
Continue?: Push ‘ON-line SW’
Write?: Push ‘feed SW’
Data bit: 8 bit
Parity: Disabled
Parity setting:
Odd number
Control flow:
H/W BUSY
Baud rate: 9600bps
9
Press the [Feed] key to
exit setting.
Setting completed
8.6.3 Printing
1) Printing can be performed by operating the foot switch (option) with the [On line] lamp
lighted by pressing the [On line] key.
2) Pressing the [Feed] key allows printer paper to be fed with the [On line] lamp turned off
by pressing the [On line] key.
3) Setting the power switch to "ON" while pressing the [Feed] key allows test printing to
be performed.
To Next Page
Loading...
