Mitutoyo HM-200A Series - 7.3 Error code list

7. TROUBLESHOOTING
No. 99MBG127A
7-3
If any other problems are encountered, contact your dealer or the nearest Mitutoyo
Service Center.
7.3 Error code list
Table7-3
Display code
Status
010
Detected the linear scale alarm signal.
011
020
Detected the linear scale non-origin signal.
021
030
Load arm origin error
040
Power turret error
050
Timer error
100
Approach parameter error
101
110
Execution error when approaching
111
120
121
140
Execution error for test force loading
141
200
Firmware version error
210
Symptom
Check point
Remedies
5
The LED
illumination is
dark.
1) The illumination is set to a low level.
1) Rise the illumination level.
2) The aperture diaphragm is too small.
2) Adjust the diaphragm.
6
Data cannot
be stored.
1) Are the backup batteries charged?
1) Turn on electricity to the unit
continuously for 8 hours.
2) " " is not used to exit.
2) Use " " to exit.