No. 99MBG127A
2-2
· Avoid installing the machine closer to the instrument which generates vibration.
· It is recommended that the installation place be on the first floor of the facility.
· Avoid installation on a facility close to the busy street with much traffic.
· Avoid installation on a facility where cranes or vibration hardness testing
machines are installed.
(The vibration may be absorbed by the hardness hardness testing machine, and it
can adversely affect the test result.)
① Test force no more than 9.807×10
-3
N(1gf):
Vibration level: 0.2 Gal or less at 5Hz or lower
(The vibration higher than 5Hz is recommended to be damped using a vibration
isolating stand.)
② Test force 9.807mN(1gf) to no more than 98.07mN(10gf):
Vibration level: 0.5 Gal or less at 5Hz or lower
(The vibration higher than 5Hz is recommended to be damped using a vibration
isolating stand.)
③ Test force 98.07mN(10gf) to no more than 1961mN(200gf):
Vibration level: 1 Gal or less at 5Hz or lower
④ Test force of 1961mN(200gf) or more
Vibration level: 5 Gal or less at 5Hz or lower
If exceeding the above condition, take the anti-vibration measure. For the anti-vibration
measure, please inquire separately.
To Next Page
Loading...
