No. 99MBG127A
3-2
Leveling bolt
Fall prevention bolt (2 pcs.)
Wrench for leveling
Level
Enlarged
view
2. Fasten the anti-overturning bolts (2pcs) to the position where the heads are away
2mm from the table. (Fig.3-2)
3. Fasten or loose the leveling bolts of both sides of the main unit with checking the
leveling.
Adjust them so that the bubble of the leveling is at the center. (Fig.3-2)
Fig. 3-2
4. Loose the anti-overturning bolts to the position where they contact the table.
At this moment, confirm that the bubble of the leveling is at the center.
If the bubble is not at the center, redo the same operation from the procedure of [2].
5. In the case that the tester is fixed with bolts (2pcs) through the hole ofφ9 at the
bottom of back side of the tester, fasten the bolts.
At this moment, confirm that the bubble of the leveling is at the center.
If the bubble is not at the center, redo the same operation from the procedure of [1].
DANGER
It is recommended that this tester should be used with being fixed by fixing bolts (2pcs)
through the hole ofφ9 at the bottom of back side of the tester.
To Next Page
Loading...
