No. 99MBG127A
● Power supply
The power supply specification of this machine
• Pollution Degree : 2
• Overvoltage Category : Ⅱ
• Class of equipment : Class Ⅰ equipment
For information about other specifications, refer to “2.1.6 Power supply”
● Power cord
Only use the supplied power cord. If there is something wrong with the power cord or
power connectors, contact Mitutoyo. Defective parts should be replaced by a Mitutoyo
service engineer.
● Removing the cover and disassembling the machine
This machine is precisely adjusted, and is comprised of high-voltage parts. In order to
prevent accident and to maintain the performance, do not absolutely remove the cover on
the machine.
● Danger prevention
In order to prevent danger, do not use the machine in locations where volatile gases could
be generated.
● Maintenance
Gently wipe off dirt from the machine using a lint-free and soft cloth. If the dirt is difficult to
remove, wipe it clean with a cloth soaked in neutral detergent, then wipe lightly with a dry
cloth or a cloth well-wrung after soaking in water. Do not use organic solvents such as
thinner or benzine.
● Take special shielding measures when using the machine in the following
locations:
Where noise is generated due to static electricity
Near strong electric fields
Where power source lines pass nearby
Where the machine could be exposed to radioactivity
Where the machine could be subjected to corrosive gases
● Be careful of unexpected machine movement when replacing the lens or
specimen.
When replacing the indenter, lens, or specimen, exercise great care to avoid personal
injury due to sudden unexpected movement of the machine.
To Next Page
Loading...
