Dansensor® Lippke® 5000 EN User Guide 19
P/N 380419-C
05/2022
Setting Up
1. Mount the nut and the washer on the vertical rod , then screw the rod into the
base plate
as far as it goes. Tighten assembly by screwing the nut against the base
plate
.
2. Fit the two handles and to the connector rod and slide it onto the vertical rod .
Tighten the handle
to position the connector rod on the vertical rod .
3. Prepare the test head - see page 22 for details - then insert it into the connector rod
and tighten handle to keep it in position.
To Next Page
