Moog IMI220-145D001 - Page 106

PARISON CONTROLLER
moog
106 MAN145-UM-D01A-EN Moog Italiana srl - Bergamo
 [036] Purge head 4 enable.
Active if the single Purge on the Work Head 4 Page is enable. It is active even used the Fast Access
Key on the front panel (All the Head).
 [037] Master Tooling active.
Not managed.
 [038] Tooling head 1 active.
Active if the single Tooling on the Work Head 1 Page is enable. It is active even used the Fast Access
Key on the front panel (All the Head).
 [039] Tooling head 2 active.
Active if the single Tooling on the Work Head 2 Page is enable. It is active even used the Fast Access
Key on the front panel (All the Head).
 [040] Tooling head 3 active.
Active if the single Tooling on the Work Head 3 Page is enable. It is active even used the Fast Access
Key on the front panel (All the Head).
 [041] Tooling head 4 active.
Active if the single Tooling on the Work Head 4 Page is enable. It is active even used the Fast Access
Key on the front panel (All the Head).
 [042] Feedback error channel 1.
Active if:
the analog input 1 is greater or equal 10000 mV and Feedback Actuator on Setup 1 Head 1 Page is
OFF;
the analog input 1 is greater or equal 10000 mV and Feedback Actuator on Setup 1 Head 1 Page is
ON and contemporarily Show Feedback on Work Head 1 Page is ON.
 [043] Feedback error channel 2.
Active if:
the analog input 2 is greater or equal 10000 mV and Feedback Actuator on Setup 1 Head 2 Page is
OFF;
the analog input 2 is greater or equal 10000 mV and Feedback Actuator on Setup 1 Head 2 Page is
ON and contemporarily Show Feedback on Work Head 2 Page is ON.
 [044] Feedback error channel 3.
Active if:
the analog input 3 is greater or equal 10000 mV and Feedback Actuator on Setup 1 Head 3 Page is
OFF;
the analog input 2 is greater or equal 10000 mV and Feedback Actuator on Setup 1 Head 3 Page is
ON and contemporarily Show Feedback on Work Head 3 Page is ON.
 [045] Feedback error channel 4.
Active if:
the analog input 4 is greater or equal 10000 mV and Feedback Actuator on Setup 1 Head 4 Page is
OFF;
the analog input 2 is greater or equal 10000 mV and Feedback Actuator on Setup 1 Head 4 Page is
ON and contemporarily Show Feedback on Work Head 4 Page is ON.