EasyManua.ls Logo

Motion Control Engineering Nidec iControl - Page 426

Default Icon
453 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
9-61
Magnetek Quattro AC Quick Reference
iControl AC
9
Adjust C0
C1 User Switches
SPD COMMAND SRC Speed Command Source none serial
multi-step
ser mult step
analog input
MULTI-
STEP
ANA-
LOG
INPUT
DRV ENABLE SRC Drive enable source. none external tb
serial
serial+extrn
EXTER-
NAL TB
EXTER-
NAL TB
BOOST ENABLE SRC Determines method in which the drive will
start precharge. Precharge is required after
drive is first powered up or after DSPR has
timed out.
none serial
enable on run
enable on de
external tb
ENABLE
ON DE
ENABLE
ON DE
RUN COMMAND SRC Run command source. Sets the source of the
run command from one of the following.
none external tb
serial
serial+extrn
EXTER-
NAL TB
EXTER-
NAL TB
HI/LO GAIN SRC High/ Low gain change switch source none internal
external tb
serial
INTER-
NAL
INTER-
NAL
SPEED REG TYPE Speed Regulator Type none elev spd reg
pi speed reg
external reg
ELEV
SPD REG
ELEV
SPD
REG
MOTOR ROTATION Allows the user to change Motor rotation. none forward
reverse
FOR-
WARD
FOR-
WARD
SPD REF RELEASE Speed reference Release none reg release
brake picked
REG
RELEASE
REG
RELEAS
E
CONT CONFIRM SRC Contactor Confirm source none external tb
none
NONE EXTER-
NAL TB
PreTorque SOURCE Pre-Torque Source none none
analog input
serial
NONE ANA-
LOG
INPUT
PreTorque LATCH Pre-Torque Latch none latched
not latched
NOT
LATCHE
D
NOT
LATCHE
D
PTorq LATCH CLCK Pre-Torque Latch Clock none external tb
serial
EXTER-
NAL TB
EXTER-
NAL TB
FAULT RESET SRC Fault Reset Source none -- external tb
-- serial
-- automatic
EXTER-
NAL TB
EXTER-
NAL TB
OVERSPD TEST SRC Overspeed Test Source none -- external tb EXTER-
NAL TB
EXTER-
NAL TB
BRAKE PICK SRC Brake Pick Source none -- internal
-- serial
EXTER-
NAL TB
INTER-
NAL
BRAKE PICK CNFM Brake Pick Confirm none none
external tb
internal time
NONE NONE
BRAKE HOLD SRC Brake Hold Source none -- internal
-- serial
INTER-
NAL
INTER-
NAL
RAMPED STOP SEL Ramp stop select none -- none
-- ramp on stop
NONE RAMP
ON
STOP
Table 10. Quattro PM Elevator Drive, iControl

Table of Contents