Motorola Solutions AP-6511 Access Point System Reference Guide
5-70
7. If adding a new NAT policy or editing the configuration of an existing policy, define the following
parameters:
Select the + Add Row button as needed to append additional rows to the IP Address Range table.
8. Select OK to save the changes or overrides made to the profile’s NAT Pool configuration. Select Reset
to revert to the last saved configuration.
9. Select the Static NAT tab.
The Source tab displays by default.
Figure 5-39 Profile Overrides - Static NAT screen
Name If adding a new NAT policy, provide a name to help distinguish it from others
with similar configurations. The length cannot exceed 64 characters.
Prefix Length Use the spinner control to set the netmask (between 1 - 30) of the network
the pool address belongs to.
IP Address Range Define a range of IP addresses hidden from the public Internet. NAT modifies
network address information in the defined IP range while in transit across a
traffic routing device. NAT only provides IP address translation and does not
provide a firewall. A branch deployment with NAT by itself will not block
traffic from being potentially routed through a NAT device. Consequently,
NAT should be deployed with a stateful firewall.
To Next Page
Loading...
