Profile Configuration
7-33
Figure 7-18 Bridge VLAN screen - General Tab
The General tab displays by default.
6. If adding a new Bridge VLAN configuration, use the spinner control to define a VLAN ID between
1 - 4095. This value must be defined and saved before the General tab can become enabled and the
remainder of the settings defined.
7. Define the following General Bridge VLAN parameters:
8. Select the OK button located at the bottom right of the screen to save the changes. Select Reset to revert
to the last saved configuration.
7.3.7 Miscellaneous Network Configuration
Profile Network Configuration
A profile can be configured to include a hostname in a DHCP lease for a requesting device and its profile.
This helps an administrator track the leased DHCP IP address by hostname for the supported device profile.
Description If creating a new Bridge VLAN, provide a description (up to 64 characters)
unique to the VLAN’s specific configuration to help differentiate it from other
VLANs with similar configurations.
Enable Edge VLAN
Mode
Select the radio button to enable edge VLAN mode. When selected, the IP
address in the VLAN is not used for normal operations, as its now designated
to isolate devices and prevent connectivity. This feature is enabled by
default.
Trust ARP Response Select the radio button to use trusted ARP packets to update the DHCP Snoop
Table to prevent IP spoof and arp-cache poisoning attacks. This feature is
disabled by default.
Trust DHCP Responses Select the radio button to use DHCP packets from a DHCP server as trusted
and permissible within the network. DHCP packets are used to update the
DHCP Snoop Table to prevent IP spoof attacks. This feature is disabled by
default.
Overlaid VLAN Select this checkbox to separate this VLAN from the wired VLAN. This
feature is disabled by default.
To Next Page
Loading...
