Profile Configuration
7-53
13.Use the parameters within the Automatic Adopted AP Firmware Upgrade field to define an
automatic firmware configuration.
14.Select OK to save the changes made to the profile’s Management Firmware configuration. Select Reset
to revert to the last saved configuration.
15.Select the Heartbeat option from the Management menu.
Figure 7-32 Profile Management Heartbeat screen
16.Select the Service Watchdog option to implement heartbeat messages to ensure other associated
devices are up and running. The Service Watchdog is enabled by default.
17.Select OK to save the changes made to the profile maintenance Heartbeat tab. Select Reset to revert
to the last saved configuration.
7.6.1 Profile Management Configuration and Deployment Considerations

Profile Management Configuration
Before defining a profile’s management configuration, refer to the following deployment guidelines to ensure
the profile configuration is optimally effective:
Enable Controller
Upgrade of AP Firmware
Select this option to enable adopted Access Point radios to upgrade to a
newer firmware version using its associated controller’s most recent
firmware file for that AP model. This parameter is disabled by default.
Number of Concurrent
Upgrades.
Use the spinner control to define the maximum number (1 - 20) of adopted
APs that can receive a firmware upgrade at the same time. Keep in mind
that, during a firmware upgrade, the AP is offline and unable to perform its
normal wireless client support function until the upgrade process is
complete.
To Next Page
Loading...
Need help?
General
