Motorola AP-6511 - Page 126

Motorola Solutions AP-6511 Access Point System Reference Guide
5-74
14.Refer to the following to determine whether a new Dynamic NAT configuration requires creation, edit or
deletion:
Select Add to create a new Dynamic NAT configuration, Edit to modify or override an existing
configuration or Delete to permanently remove a configuration.
Figure 5-43 Dynamic NAT Add screen
Source List ACL
Lists an ACL name to define the packet selection criteria for the NAT
configuration. NAT is applied only on packets which match a rule defined in
the access-list. These addresses (once translated) are not exposed to the
outside world when the translation address is used to interact with the
remote destination.
Network
Displays Inside or Outside NAT as the network direction for the dynamic
NAT configuration.
Interface
Lists the VLAN (between 1 - 4094) used as the communication medium
between the source and destination points within the NAT configuration.
Overload Type
Select the radio button to define the Overload Type used with the listed IP
ACL rule. Options include NAT Pool, One Global Address and Interface IP
Address. Interface IP Address is the default setting.
NAT Pool
Displays the name of an existing NAT pool used with the dynamic NAT
configuration.
Overload IP
If One Global IP Address is selected as the Overload Type, define an IP
address used a filter address for the IP ACL rule.