Motorola Solutions AP-6511 Access Point System Reference Guide
5-80
Figure 5-46 Profile Overrides - Management Firmware screen
10.Select the Enable Configuration Update radio button (from within the Automatic Configuration
Update field) to enable automatic configuration file updates for the profile from a location external to
the device.
If enabled (the setting is disabled by default), provide a complete path to the target configuration file
used in the update.
11.Refer to the Automatic Firmware Upgrade field to define or override the configuration used by the
profile to update device firmware.
12.Use the parameters within the Automatic Adopted AP Firmware Upgrade field to define an
automatic firmware upgrade from a local file.
13.Select OK to save the changes and overrides made to the profile’s Management Firmware configuration.
Select Reset to revert to the last saved configuration.
Enable Firmware
Upgrade
Select this option to enable automatic firmware upgrades (for this profile)
from a user defined remote location. This value is disabled by default.
Enable Controller
Upgrade of AP Firmware
Select this radio button to enable adopted Access Point radios to upgrade
to a newer firmware version using a resident firmware file for that AP
model. This parameter is disabled by default.
Number of Concurrent
Upgrades.
Use the spinner control to define the maximum number (1 - 20) of adopted
APs that can receive a firmware upgrade at the same time. Keep in mind
that during a firmware upgrade, the AP is offline and unable to perform its
normal wireless client support function until the upgrade process is
complete.
To Next Page
Loading...
