Wireless Configuration
6-27
Figure 6-12 WLAN Policy Client Settings screen
4. Define the following Client Settings for the WLAN:
Disallow
Client-to-Client
Communication
Select this option to disallow client to client communication within this WLAN.
The default is enabled, meaning clients are allowed to exchange packets with
other clients. It does not necessarily prevent clients on other WLANs from
sending packets to this WLAN, but as long as this setting also disabled on that
WLAN, the clients are not permitted to interoperate.
Wireless Client
Power
Use this parameter to set the maximum transmit power (between 0 - 20 dBm)
communicated to wireless clients for transmission. The default value is 20
dBm.
Wireless Client Idle
Time
Set the maximum amount of time wireless clients are allowed to be idle within
this WLAN. Set the idle time in either Seconds (60 - 86,400), Minutes (1 -
1,440), Hours (0 - 24) or Days (0 - 1). When this setting is exceeded, the client
is no longer able to access resources and must re-authenticate. The default
value is 1,800 seconds.
Max Firewall
Sessions per Client
Select this option to set the maximum amount of sessions (between 10 -
10,000 clients) over the Firewall. When enabled, this parameter limits the
number of simultaneous sessions allowed by the Firewall per wireless client.
This feature is disabled by default.
Enforce Client Load
Balancing
Select the checkbox to distribute clients evenly amongst associated Access
Point radios. This feature is enabled by default.
To Next Page
Loading...
Need help?
General
