Wireless Configuration
6-63
17.Select OK to update the Smart RF Interference Recovery settings for this policy. Select Reset to revert
to the last saved configuration.
18.Select the Coverage Hole Recovery tab.
Figure 6-29 Smart RF Advanced Configuration screen - Coverage Hole Recovery tab
19.Set the following Coverage Hole Recovery for 5.0 GHz and 2.4 GHz parameters:
Client Threshold Use the spinner to set a client threshold for the Smart RF policy between
1 - 255. This is the minimum number of clients a radio should have
associated in order for coverage hole recovery to trigger. The default
setting is 1.
SNR Threshold Use the spinner control to set a signal to noise threshold (between 1 - 75
dB). This is the signal to noise threshold for an associated client as seen
by its associated AP radio. When exceeded, the radio increases its
transmit power in order to increase coverage for the associated client. The
default value is 20 dB.
Coverage Interval Define the interval coverage hole recovery should be initiated after a
coverage hole is detected. The default is 10 seconds for both the 2.4 and
5.0 GHz radios.
Interval Define the interval coverage hole recovery should be conducted after a
coverage hole is detected. The default is 30 seconds for both the 2.4 and
5.0 GHz radios.
To Next Page
Loading...
