Profile Configuration
7-27
address as its own returns a reply so indicating. ARP updates the ARP cache for future reference and then
sends the packet to the MAC address that replied.
To define an ARP supported configuration:
1. Select Configuration > Profiles > Network.
2. Expand the Network menu to display its submenu options.
3. Select ARP.
4. Select + Add Row from the lower right-hand side of the screen to populate the ARP table with rows used
to define ARP network address information.
Figure 7-14 ARP screen
5. Set the following parameters to define the ARP configuration:
VLAN Use the spinner control to select a VLAN for an address requiring resolution.
IP Address Define the IP address used to fetch a MAC Address.
MAC Address Displays the target MAC address that’s subject to resolution. This is the MAC
used for mapping an IP address to a MAC address that’s recognized on the
network.
Device Type Specify the device type the ARP entry supports (Host, Router or DHCP Server).
Host is the default setting.
To Next Page
Loading...
