Security Configuration
8-19
Figure 8-11 WIPS Events screen - AP Anomaly tab
AP Anomaly events are suspicious frames sent by a neighboring APs. Use this screen to determine
whether an event is enabled for tracking.
16.Set the configurations of the following MU Anomaly Events configurations:
17.Select OK to save the updates to the AP Anomaly configuration used by the WIPS policy. Select Reset
to revert to the last saved configuration.
18.Select the WIPS Signatures tab.
Name Displays the name of the MU Anomaly event. This column lists the event
being tracked against the defined thresholds set for interpreting the event
as excessive or permitted.
Enable Displays whether tracking is enabled for each MU Anomaly event. Use the
drop-down menu to enable/disable events as required. A green checkmark
defines the event as enabled for tracking against its threshold values. A
red “X” defines the event as disabled and not tracked by the WIPS policy.
Each event is disabled by default.
To Next Page
Loading...
