Motorola Solutions AP-6511 Access Point System Reference Guide
9-22
14.Select OK when completed to update the static bindings configuration. Select Reset to revert the screen
back to its last saved configuration.
15.Select the Advanced tab to define additional NetBIOS and Dynamic DNS parameters.
Figure 9-12 DHCP Pools screen - Advanced tab
16.The addition or edit of the network pool’s advanced settings requires the following General parameters
be set:
Boot File Enter the name of the boot file used with this pool. Boot files (Boot
Protocol) can be used to boot remote systems over the network. BOOTP
messages are encapsulated inside UDP messages so requests and replies
can be forwarded. Each pool can use a different file as needed.
BOOTP Next Server Provide the numerical IP address of the server providing BOOTP resources.
Enable Unicast Unicast packets are sent from one location to another location (there's just
one sender, and one receiver). Select this option to forward unicast
messages to just a single device within the network pool.
To Next Page
Loading...
