Motorola Solutions AP-6511 Access Point System Reference Guide
10-12
Figure 10-7 Management Policy screen - SNMP tab
2. Enable or disable SNMPv2 and SNMPv3.
Enable SNMPv2 Select the checkbox to enable SNMPv2 support. SNMPv2 provides device
management using a hierarchical set of variables. SNMPv2 uses Get,
GetNext, and Set operations for data management. SNMPv2 is enabled by
default.
Enable SNMPv3 Select the checkbox to enable SNMPv3 support. SNMPv3 adds security
and remote configuration capabilities to previous versions. The SNMPv3
architecture introduces the User-based Security Model (USM) for message
security and the View-based Access Control Model (VACM) for access
control. The architecture supports the concurrent use of different security,
access control and message processing techniques. SNMPv3 is enabled
by default.
To Next Page
Loading...
