MUTOH ValueJet VJ-1624X - Page 211

VJ-1624X/1624WX/1924WX OPERATION MANUAL 5 Panel setup menu
5.1 Setup menu 211
Slant Check Sets up slanting detection during media loading.
• [Enter] key: shifts to the sub menu.
5.1.14 Slant Check menu
Auto Cleaning Sets up the time for auto cleaning during standby, before printing, and during printing.
• [Enter] key: shifts to the sub menu.
5.1.15 Auto Cleaning menu
Ink Status Displays the various information about Ink cartridges (ink status) that are installed in Slots.
• [Enter] key: shifts to the sub menu.
5.1.16 Ink Status menu
Roll Length Sets up the roll media length.
• [Enter] key: shifts to the sub menu.
5.1.17 Roll Length menu
Exhaust fan Set the operation of Exhaust fan.
• [Enter] key: shifts to the sub menu.
5.1.18 Exhaust Fan menu
Longstore Wash Print head with the cleaning fluid.
• [Enter] key: shifts to the sub menu.
5.1.19 Longstore menu
CR Maint. Performs maintenance.
• [Enter] key: shifts to the sub menu.
5.1.20 CR Maintenance menu
Initialization Returns the settings of the printer to default.
• [Enter] key: shifts to the sub menu.
5.1.21 Initialization menu
Life Times Displays the operational life time of each part.
• [Enter] key: shifts to the sub menu.
5.1.22 Life Times menu
IP Address Sets the IP address of the printer.
• [Enter] key: shifts to the sub menu.
5.1.23 IP Address menu
Subnet Mask Sets the subnet mask of the printer.
• [Enter] key: shifts to the sub menu.
5.1.24 Subnet Mask menu
Gateway Sets the gateway.
• [Enter] key: shifts to the sub menu.
5.1.25 Gateway menu
Header dump Set whether or not to display the Header dump menu.
•[Enter] key: shifts to the sub menu.
5.1.26 Header Dump menu
Start Feed Rewinds or feeds the media the amount specified by the set value.
• [Enter] key: Moves to the sub menu.
5.1.27 Start Feed Menu
Heater Control You can set the heater operations based on your usage environment.
• [Enter] key: shifts to the sub menu.
5.1.28 Heater Control menu (VJ-1628X only)
Setup item Description