5 Panel setup menu VJ-1624X/1624WX/1924WX OPERATION MANUAL
218 5.1 Setup menu
5.1.1.1.2 Adjust Print menu
Sets up when adjusting the printer for the optimum quality of image print.
• This printer was adjusted at the factory shipment so that it obtains the optimum printing quality.
Adjust the quality if the print quality changes after the installation environment or the media is
changed.
• When newly setting or changing the user type setting after adjusting Standard adjust print, make
sure to adjust print.
• Since all print modes are adjusted at once after performing Custom adjust print, adjust print is not
required even after changing the print mode.
• When specifying a print mode which is different from the mode set in the user type setting, adjust
all print modes in the Custom adjust print first.
Media thickness menu
• The settings here are the same as .5.1.1.1.8 Media thickness menu
Setup item Setting Description
Adjust Print Media Thickness Shifts to the menu where you can enter the thickness of the
media you are using.
5.1.1.1.8 Media thickness menu
— • [Cancel] key: shifts to the previous menu.
5.1.1.1 User Type advanced setup menu
Setup item Setting Description
Media Thickness
80
µm to <170µm> to
2800
µm
Enter the thickness of the media you are using.
• [Enter] key: saves the setting and shifts to the sub menu.
Standard Adjust Print menu
Custom Adjust Print menu
— • [Cancel] key: shifts to the previous menu.
5.1.1.1 User Type advanced setup menu
To Next Page
Loading...
Need help?
General