6 Maintenance VJ-1624X/1624WX/1924WX OPERATION MANUAL
302 6.2 Cleaning the printer
4. Press the [Cleaning] key on Operation panel for more than two seconds.
• Head cleaning starts.
• "Cleaning **%" is displayed on Operation panel.
• After Head cleaning is complete, Operation panel shifts to Normal.
• For VJ-1624WX/1924WX, to perform head cleaning during printing while the head height is set to
High, make sure to do the following.
• When "Change Head Gap Low" is displayed on Operation panel, set the head height to Low.
• After head cleaning is complete, "Change Head Gap High" is displayed on Operatino panel. Set
the head height to High. After changing the setting, printing starts.
4.2.5 Head height adjustment
• For VJ-1624X, auto cleaning can be performed regardless of the head height.
• If blurs or lacking parts in printed media do not disappear with one time of Head cleaning, perform
Strong cleaning.
• If blurs or lacking parts in printed media do not disappear with several times of Head cleaning, refer
to 7 Troubleshooting, and take appropriate measures.
To Next Page
Loading...
Need help?
General