NAiS FP Series Hardware Manual

FP0 Hardware 9.7 Wiring the MIL Connector
9-15Matsushita Electric Works (Europe) AG
4. When all wires has been inserted, fit the semi-cover into
place.
semi-cover
Note
If using a MIL connector for flat cables, please specify the order
number AXM110915.
9.7.1 Contact Puller Pin for Rewiring
If there is a wiring mistake or the cable is incorrectly pressure-connected, the contact
puller pin provided with the fitting can be used to remove the contact.
Press the housing against the pressure connection tool so that
the contact puller pin comes in contact with this section.

NAiS FP Series Specifications

General

Brand	NAiS
Model	FP Series
Category	Controller
Language	English