FP0 Hardware 1.5 Programming Tools
1-9Matsushita Electric Works (Europe) AG
1.5 Programming Tools
Type
Description
Order
number
PC software FPWIN Pro Program editing windows software for use with
commercially available computers. (System required: IBM
compatible with Pentium 1 processor, 60MB free hard disk,
CD–ROM drive, 32MB RAM (recommended), and
Windows 3.11/95/98/2000/NT.)
FPWINPro
C/F/S/U
DED/END/
FRD
FPWIN GR
Program editing windows software for use with
commercially available computers. (System required: IBM
compatible with Pentium 100MHz processor, 15MB free
hard disk, 32MB RAM (recommended), and Windows
95/98/NT.)
FPWINGR
FD
By summer
2001: Ital.
and Span.
versions
FP PC cable
Cable needed for connection between the tool port of FP0
control unit and the RS232C port (25 pins) of RS232C port
adapter.
AFC8513
(3m/9.84ft.)
(see note 2)
Programmer FP programmer II
Ver. 2 (see note 1)
Handheld programming device
AFP1114V2
FP peripheral cable Cable needed for connection between the tool port of FP0
control unit and the FP programmer II’s communication
port.
AFC8521
(1m/3.28ft.)
AFC8523
(3m/9.84ft.)
Notes
1) When FP programmers (AFP1112A/AFP1114) are used, reading
and writing of the following FP0 instructions are not possible
and the functions cannot be used.
– High–speed counter function (related
instructions: F166/F167)
– Pulse output function (related instructions:
F168/F169)
– PWM output function (related instruction: F170)
– 1ms unit timer instruction (TML)
– 32–bit auxiliary timer instruction (F183)
– Changing the communication baud rate to
19,200bps (factory setting is 9600bps)
2) If the FP PC cable (AFC8513) is to be connected to a computer
(IBM PC/AT compatible), use a commercially available 9 pin –
25 pin port adapter.