FP0 HardwareFP0 I/O Link Unit (MEWNET–F)
5-4
Matsushita Electric Works (Europe) AG
5.2 Precautions for Handling
In addition to the precautions taken for all FP0 components (see Before You Start),
adhere to the following:
When handling numerical data, have the FP0 I/O
Link Unit read the data twice because the unit does
not guarantee the simultaneity of data.
Turn OFF the power when wiring the FP0 I/O Link
Unit or when adding an FP0 I/O Link Unit.
Be careful not to leave wire wastes inside the units
when wiring.
Do not touch the unit’s expansion connector with
your hand. This may result in a poor contact, and
the static electricity from your hand may damage the
components.
Do not bang or drop the FP0 I/O Link Unit as its case
is made of resin.
Keep the unit as far away as possible from
high–voltage or high–current cables, high tension
equipment, power generating equipment and radio
equipment.
Separate the wiring for the power supply lines and
the transmission lines in separate conduits. At the
very least they should be separated as far away
from each other as possible.
!
To Next Page
Loading...
Need help?
General
