Programming
Programming Basics
102 ◆ Networking
How to Enter the Programming Mode
To enter the programming mode:
1. Go to any working display telephone.
In a newly installed system, use extension 301 (port 1).
2. Do not lift the handset.
3. Press CALL1.
4. # * # *
5. Dial the system password + HOLD.
Refer to the following table for the default system passwords. To change the pass-
words, use Program 90-02.
Note: When changes are made to the following programs, the Aspire system must be restarted.
Password
Password User Name Level Programs at this Level
374772 NEC-I 1 (MF) All programs
12345678 ASPIRE 2 (IN) All programs in this section not listed below for SA and SB
0000 ADMIN1 3 (SA) 10-01, 10-02, 10-12, 10-13, 10-14, 10-15, 10-16, 10-17, 10-18,
10-22, 12-02, 12-03, 12-04, 15-01, 15-07, 15-09, 15-10, 15-11,
20-16, 21-07, 21-14, 22-04, 22-11, 25-08, 30-03, 32-02, 40-02,
41-02, 41-03, 41-04, 41-05, 41-06, 41-07, 41-08, 41-09, 41-10,
41-11, 41-12, 41-13, 41-14, 41-15, 41-16, 41-17, 41-18, 90-03,
90-04, 90-06, 90-07, 90-18, 90-19
9999 ADMIN2 4 (SB) 13-04, 13-05, 13-06
10-12-01 10-16-01 80-02-03 84-04 84-06-07
10-12-02 10-16-02 80-02-04 84-05-01 84-06-08
10-12-03 10-16-03 80-03 84-05-02 84-06-09
10-12-04 10-16-04 80-04 84-06-01 84-06-10
10-13-01 20-01-03 84-03-01 84-06-02 84-06-11
10-13-02 47-01-01 84-03-02 84-06-03 84-09
10-13-03 80-01 84-03-06 84-06-04 84-10
10-14 80-02-01 84-03-07 84-06-05
10-15 80-02-02 84-03-08 84-06-06
To Next Page
Loading...
