Programming
11-10 : Service Code Setup (for System Administrator)
146 ◆ Networking
Conditions
None
Feature Cross Reference
Refer to chart above.
Telephone Programming Instructions
To enter data for Program 11-10 (Service Code Setup (for System Administrator)):
1. Enter the programming mode.
2. 11 10
3. Enter the number of the item you want to program.
4. Enter data for the item you selected + HOLD.
5. Enter data for the next item in the program.
OR
Press MSG once to enter a new item number.
OR
Press MSG until you’ve exited that series’s programming section.
34 Set Caller ID Refuse
DeÞne the service code to be used to enable/disable
the Caller ID call refusal for the trunks which are pro-
grammed in Program 14-01-27 to 1.
No Setting 14-01-27
35 DID Mode Switching
Assign the service code to be used to manually change
the time pattern for a DID number.
KST, SLT No Setting
11-10-01
NT-Mode_Switch *01
back
↑↑
↑↑
↓↓
↓↓
select
11-10-nn
nnnnn
←←
←←
→→
→→
Item
No.
Item Terminals Default New
Related
Program
To Next Page
Loading...
