Programming
44-03 : Dial Analysis Extension Table
200 ◆ Networking
44-03 : Dial Analysis Extension Table
Description
When Program 44-02-02 is set to type “3”, use Program 44-03 : Dial Analysis Extension Table to
set the dial extension analysis table. These tables are used when the analyzed digits must be more
than 8 digits. If the received digits do not match the digits set in tables 1-250, table number 252 is
used refer to the next Extension Table Area (1-4) to be searched. If the received digits are not iden-
tiÞed in tables 1-250, the F-Route selection table number deÞned in table 251 is used.
Note: The item numbers indicated below are different when using PCPro/WebPro due to the win-
dow layout of the applications. Refer to the program within the PCPro/WebPro application
to determine the correct item number.
Input Data
Dial Analysis Table Number : 1-250
Dial Analysis Table Number : 251
Level:
Aspire S Aspire M/L/XL
IN • Available. • Available.
• Applicable to IP and ISDN Networking. • Applicable to IP and ISDN Networking.
Extension Table Area Number 1-4
Dial Analysis Table Number 1-252
Item
No.
Item Input Data Default
01 Dial Up to 24 digits
Digits = 1-9, 0, *, #, @
(Press Line Key 1 for wild character @)
No setting
02 ARS/F-Route
Select Table
Number
0-500 (ARS/F-Route Table Number)
With Program 44-01 set to 0, Program 44-05 is then checked.
With Program 44-01 set to 1, Program 44-04 is then checked.
0
Item
No.
Item Input Data Default
03 ARS/F-Route
Select table
Number
0-500 (ARS/F-Route Table Number)
With Program 44-01 set to 0, Program 44-05 is then checked.
With Program 44-01 set to 1, Program 44-04 is then checked.
0
To Next Page
Loading...
