Features
Department Calling
62 â—† Networking
Department Calling
Department Calling
Department Group access is available via Networking. When the extension at System A tries to
make a Department Call to System B, System A should have a numbering plan which deÞnes the
Department Access code at System-B (must be deÞned as dial type 8, Networking in Program 11-
01 : System Numbering).
The following Department Calling options are supported with the Networking feature.
Operation
1. When dialing the Department access code for the networked system, the call is dialed in the
the same way normal.
2. A Department Call from the outgoing system will be routed to an available extension in the
Department Group.
Program Number Mode Same as Single System
16-01-02 Department Calling Cycle Yes
16-01-03 Department Routing When Busy Yes
16-01-04 Hunting Mode No
16-01-05 All Ring Mode When a call is transferred to a
Department Group with All Ring,
there is a difference in operation. In a
single system, an extension within
the same system can transfer a call to
a Department Group and the call will
ring an extension within the Depart-
ment Group once the transferring
user hangs up. In a networked sys-
tem, the transfer will not go through
and the call will recall the extension
performing the transfer.
16-01-06 STG Withdraw Mode No
16-01-07 Call Recall Restriction for STG No
16-01-08 Maximum Queuing Number No
16-01-10 Enhanced Hunting Mode No
To Next Page
Loading...
Need help?
General
