Programming
84-04 : VOIPU PCB DHCP Server Mode Setup
Networking ◆ 227
84-04 : VOIPU PCB DHCP Server Mode Setup
Description
Use Program 84-04 : VOIPU PCB DHCP Server Mode Setup to determine whether the VOIPU
PCB should use a manually assigned IP Address or if it should obtain its IP Address from a DHCP
server.
Input Data
Conditions
The system programming must be exited before this program option takes affect.
Feature Cross Reference
● VoIP
Level:
Aspire S Aspire M/L/XL
MF • Available. • Available.
• Applicable to IP Networking. • Applicable to IP Networking.
• With software 2.63+, this program requires
the manufacturer level password.
• With software 2.63+, this program requires
the manufacturer level password.
Item No. Description Input Data Default
01 DHCP Server Mode
DeÞne whether or not the DHCP Server is used.
If this item is set to 0:Disable, the values in Pro-
gram 84-05 will be used.
If this item is set to 1:Enable, the VOIPU will try
to obtain an IP address from a DHCP Server. The
DHCP server could be external (i.e. on the LAN),
or could be the NTCPU (if Program 10-13-01 is
enabled)
0:Disable
1:Enable
0
To Next Page
Loading...
