Programming
22-12 : DID Intercept Ring Group
Networking ◆ 183
22-12 : DID Intercept Ring Group
Description
For each DID Translation Table, use Program 22-12 : DID Intercept Ring Group to deÞne the
Þrst destination group for DID calls.
Depending on the entry in Program 22-09-02 and 22-11-04, the incoming calls will route to the Þrst
destination group by the following:
● Vacant number intercept (vacant number means that there is no phone connected, no station
card installed, or the extension number is not deÞned in Program 11-02)
● Busy intercept
● Ring-no-answer intercept
If the destination is '0', the calls will be forwarded to the trunk ring group deÞned in Program 22-11
based on the table assigned to the DID trunk.
Note: If Program 22-11-05 and 22-11-06 are set, the priority of transferring will be in this order:
Program 22-11-05 ☞ Program 22-11-06 ☞ Program 22-12.
For busy and no-answer calls, if the Þrst and third destinations are programmed but the sec-
ond destination is not, the incoming call goes to the third destination after the Þrst destina-
tion. If the Þrst and second destinations are not deÞned, but the third destination is, the call
goes directly to the third destination (as deÞned in Program 22-12).
Input Data
Conditions
None
Feature Cross Reference
● Direct Inward Dialing (DID)
Level:
Aspire S Aspire M/L/XL
IN • Available. • Available.
• Applicable to IP and ISDN Networking. • Applicable to IP and ISDN Networking.
Conversion Table Area Number 01-20
Item No. Day/Night Mode Incoming Group Number Default
01 Aspire S: 1-4
Aspire: 1-8
0 (No Setting)
1-8 or 1-100 (Incoming Group)
101 (DSPDB Voice Mail)
102 (In-Skin/External Voice Mail)
103 (Centralized Voice Mail)
1
To Next Page
Loading...
