Programming
45-01 : Voice Mail Integration Options
216 ◆ Networking
Conditions
None
Feature Cross Reference
● Voice Mail
05 Message Wait
Enable/disable the system’s ability to pro-
cess the Voice Mail’s Message Wait (#)
commands. You should normally enable
this option. If enabled, be sure that the
programmed Message NotiÞcation strings
don’t contain the code #9 for trunk
access.
0 = Off
1 = On
1
06 Record Alert Tone Interval Time
This timer sets the interval between voice
Mail Conversation Record alerts
0-64800 seconds 0
07 Mailbox Number
Enter the extension number of the voice
mail to be accessed as the centralized
voice mail unit when the Networking fea-
ture is used.
Up to 8 Digits -
08 Networked Voice Mail Department
Group Number
Assign which Extension (Department)
Assign which Extension (Department)
Group number is to be assigned as the
voice mail group with a networked sys-
tem. An entry of ‘0’ means there is no
voice mail installed. When using Central-
ized Voice Mail with Aspire Mail or Intra-
Mail, this program and Program 45-01-01
must both be programmed with the same
group number. Otherwise, the audio path
may not connected properly.
Aspire S: 0 - 8
Aspire: 0 - 64
(0=no voice mail)
0
09 Networked Voice Mail Master Name
Enter the Voice Mail master name
(networked system).
Up to 12 Characters C.V.M.
10 NSL Protocol Support
Aspir
e M/L/XL Only
This option must be enabled (1) in order
for the display to use the NSL protocol.
0 = NSL Protocol Disabled
1 = NSL Protocol Enabled
0
To Next Page
Loading...
