Features
911 Call Routing
Networking ◆ 39
911 Call Routing
911 Call Routing : Using ARS Class of Service Matching to Call
Local Authorities
When using IP telephones at a remote site (System B) which are registered to the main system
(System A), you can use the ARS Class of Service Matching feature added in software 2.63 to route
911 calls to the local authorities at the remote location. Without this programming, since the phones
are registered to the main site, when 911 calls are placed by IP phones, the local authorities at the
main site (System A) would be called.
This option requires Aspire software 2.63 and higher and the following programs are set in the
main system (System A).
Related Programs
Each remote site needs to have a different ARS Class of Service. If, for example, there were 50 IP
sets on one remote site, each would use the same ARS Class of Service.
It is important to remember that there must be a trunk available to make a call across the network
from the main system. Then, by default, the system will access the Þrst available trunk in trunk
group 1 at the remote side to place the 911 call.
Program Number Title
10-27-01 IP System ID
• For each network node, assign an ID and corresponding IP address
of the networked IP system.
26-01-01 Automatic Route Selection Service - ARS Service
• Enter “1” to enable ARS.
26-01-06 Automatic Route Selection Service - COS Match Access
• Enter “1” to enable COS Matching.
26-04-01 ARS Class of Service
• Assign the IP extension’s ARS Class of Service (0-16).
26-02-01 Dial Analysis Table for ARS /LCR - Dial
•DeÞne the Dial Analysis Table. Enter “911” in a table.
26-02-02 Dial Analysis Table for ARS /LCR - Service Type
• For the 911 Dial Analysis Table, enter the “1” to route the call to a
trunk group.
Note: With PCPro/WebPro, the option is displayed as “Incoming Ring
Group”.
26-02-03 Dial Analysis Table for ARS /LCR - Additional Data
• Enter the network ID number which corresponds to the entry in
Program 10-27 preceded by “1”. (For example: ID 01 is entered as
“101”, 02 is entered as “102”, etc.)
26-02-04 Dial Analysis Table for ARS /LCR - ARS Class of Service
• Assign the ARS COS to the 911 Dial Analysis Table.
To Next Page
Loading...
