NEC Aspire Series User Manual

Programming
26-03 : ARS Dial Treatments
Networking ◆ 193
26-03 : ARS Dial Treatments
Description
Use Program 26-03 : ARS Dial Treatments to assign the 15 Dial Treatments for automatic ARS
dialing translation. Assign Dial Treatments to Service Numbers (Trunk Groups) in Program 26-02.
The ARS Dial Treatment options are:
● 3 - Delete the NPA if dialed as part of the initial call.
Requires at least 8 digits in the ARS table (Program 26-02-01).
● 2 - Delete the leading “1” if dialed as part of the initial call.
Requires at least 8 digits in the ARS table (Program 26-02-01).
● 1 - Add a leading 1 if not dialed as part of the initial call.
Requires at least 8 digits in the ARS table (Program 26-02-01).
● INPA - Insert the NPA speciÞed by NPA.
● DNN - Outdial the NN number of digits or execute the code that follows. For example,
D041234 out-dials 1234. Valid entries are 0-9, #, *, Wnn (wait nn seconds) and P (pause).
Each digits code counts as a digit. So for example, if a P was added for a pause, the entry
would look like: D05P1234. This Dial Treatment can only be added from telephone program-
ming.
● Wnn - Wait nn seconds.
● P - Pause in analog trunk.
● R - Redial the initially dialed number, including any modiÞcations
● E - End of Dial Treatment. All Dial Treatments must end with the E code.
● X - When ARS is enabled, X must be entered in the Dial Treatment in order for the system to
output the extension number of the call’s originator to the black box for the E911 feature.
● An - For Alternate Carrier Access (n = 1 ~ 4). The numeric digit instructs the system to insert
a Transit Network Selection information element in the SETUP message and also identiÞes
which code in Program 26-11 will be included in the information element. This function is
valid only for outbound calls by ISDN trunks.
Input Data
Conditions
None
Level:
Aspire S Aspire M/L/XL
IN
• Available. • Available.
• “An” Dial Treatment available with 2.64+
software.
• “An” Dial Treatment available with 2.64+
software.
Dial Treatment Table Number 1-15
Item No. Input Data Default
01 24 characters maximum No Setting

NEC Aspire Series Specifications

General

Series	Aspire
Protocols	SIP, H.323
Lines	IP
Extensions	Digital, IP
Voicemail	Integrated Voicemail System
Networking	IP Networking
Power Supply	100-240V AC, 50/60Hz
Dimensions	Varies depending on the system module
Weight	Varies depending on the system module