Programming
10-03 : PCB Setup
Networking ◆ 115
For PRIU Unit
Item
No.
Item Input Data Default
01 ISDN Line Mode 0 = Not set
1 = T-Bus
2 = S-Bus
3 = Network Mode (Leased Line)
4 = Network Mode (Interconnected Line)
5 = Network Mode (Interconnected Line, Fixed Layer 1=NT)
6 = S-Point (Leased Line)
1
02 Logical Port Number
(see Note 1)
1 = for T-Bus 1-200
2 = for S-Bus Through Software 3.07: 1-256
From Software 4.0E+: 1-384
0
03 CRC Multi-frame(CRC4)
(Only E1[30B+D] Mode)
0 = off
1 = on
0
04 Layer 3 Timer Type (see Note 2) 1-5 1
05 CLIP Information
Based on this setting, the system will
include a “Presentation Allowed” (1)
or “Presentation Restricted” (0) in the
Setup message to allow or deny the
Calling Party Number. Program
15-01-04 must also be set to a ‘1’ if
this option is enabled.
0 = Disable
1 = Enable
1
06 Length of cable 0 = 0 40m
1 = 40 81m
2 = 81 122m
3 = 122 162m
4 = 162 200m
0
07 S-Point DID Digits 0-4 0
08 Dial Sending Mode 0 = Enblock Sending
1 = Overlap Sending
0
09 Dial Information Element
(Only for Overlap Sending Mode)
0 = Keypad Facility
1 = Called Party Number
0
10 Master/Slave System (Network Mode
only)
0 = Slave System
1 = Master System
0
11 Networking System Number
(Network Mode only)
0-50 0
12 Short / Long-haul 0 = short-haul
1 = long-haul
0
To Next Page
Loading...
