Programming
11-01 : System Numbering
132 ◆ Networking
● Changing the Dial Type for a range of codes can have a dramatic affect on how your sys-
tem operates. Assume, for example, the site is a hotel that has room numbers from 100-
399. In order to make extension numbers correspond to room numbers, you should:
- Change the Dial Type for the digit 1 from 1 (Service Code) to 2 (extension number).
- Change the Dial Type for the digit 7 from 2 (extension number) to 1 (Service Code).
- In Program 11-02, reassign extension numbers on each ßoor from 100 to 399.
- In Programs 11-10 through 11-15, reassign the Service Codes from the 100 series (e.g.,
116) to the 700 series (e.g., 716). (Other applications might also require you to change
entries in Program 11-10 through 11-15.)
- Check Program 11-16 to be sure that the Single Digit Service Code 04 (digit 7) does not
affect any post dial Service Codes codes in Programs 11-10 through 11-15. (Unless you
changed codes from their default assignments, this would not be the case.)
- In Program 45-01-03, enter “0” to disable Voice Mail Call Screening. If you left screen-
ing enabled, Voice Mail ports could call the wrong extensions. For example, a Voice
Mail port trying to call screen extension 130 would outdial 1130. This would call exten-
sion 113 instead.
Extension numbers now will correspond to room numbers, and all the Service Codes in
the 100 series will be in the 700 series.
Default
See the following tables.
To Next Page
Loading...
Need help?
General
