NEC express5800 A2010b - Page 325

7. Using Remote Management
Chapter 3 Setup
Setting range and default value
Item name Setup value(*1)
Default
setting(*2)
IPv6
Enable or disable IPv6.
Enable/Disable
Disable
IPv6 Address Assign Mode (*3)
Specify IPv6 Address Assign Mode.
Dynamic/Static
Dynamic
IPv6 Address
IPv6 Link Local Address (Master)
Display IPv6 Link Local Address. (*5)
IPv6 Link Local Address (Standby)
Display IPv6 Link Local Address.(*5)
Not displayed with A1040b model.
IPv6 Current Statis Address (*3)
Specify the current static address. (*8)
Ex.: 2012:629:1409:ABCD::2
0::0
IPv6 Prefix Length (*3)(*4)
Specify the IPv6 prefix length in the range between 0 and 64 (*9).
64
IPv6 Global Address (*6)(*7)
Display Ipv6 global address that is appended by RA.
IPv6 Gateway Address (*3)
IPv6 Gateway Address (*3)
Specify IPv6 Gateway address.(*8)
Ex.: 2012:629:1409:ABCD::4
0::0
(*1) Addresses and character strings are example.
(*2) Factory-set value.
(*3) Displayed when IPv6 is set to "Enable" and "Static" is specified for IPv6 Address Assign Mode.
RA (Router Advertisement) is supported in Dynamic mode. DHCP is not supported.
(*4) Displayed when IPv6 Address Assign Mode is set to "Static".
(*5) Even if IPv6 is set to "Disable", Link Local Address is always assigned.
(*6) IPv6 Global Address is assigned to master BMC, not standby BMC.
(*7) Displayed when IPv6 Address Assign Mode is set to "Dynamic".
(*8) Up to 43 ASCII characters (A to F, a to f, 0 to 9, and colon ":" can be accepted.
(*8) ASCII numeric characters (0 to 9) between 0 and 64 digits can be accepted.
Buttons
① [Apply] button
Apply the edited value and return to List page.
② [Default] button
Set the factory-set value. This value is not applied unless [Apply] button is pressed.
③ [Cancel] button
Return to List page without applying the edited value.
Express5800/A1040b, A2040b, A2020b, A2010b User's Guide
325